The BMW Part Spring Pocket 41147057297 is a crucial component in BMW vehicles, specifically designed to ensure the smooth operation of the vehicle’s suspension system. This part, also known as the spring seat, plays a vital role in securely holding the spring in place, thereby maintaining the vehicle’s stability and ride comfort. Its robust construction and precise fitment are essential for the overall performance and longevity of the suspension system, making it an indispensable part of BMW’s engineering excellence.
The BMW Part Spring Pocket 41147057297, also known as the 41-14-7-057-297, is a genuine BMW part designed as a spring seat or holder. It is a direct replacement part, meaning it can be installed without modifications. The part weighs approximately 0.90 pounds (0.41 kg).
This part is compatible with a range of BMW models, including:
E82
E90
E92
E93
F22
F30
F31
F32
F33
F34
F36
F80 M3
F82 M4
F83
The part number for this spring pocket is 41147057297.
It is typically used in the rear suspension of these vehicles and is essential for maintaining the proper function of the suspension system.
Prepare the Vehicle: Ensure the vehicle is parked on a flat surface and the parking brake is engaged. Disconnect the battery to prevent any electrical issues.
Lift the Vehicle: Use a hydraulic jack to lift the vehicle and secure it with jack stands. Ensure the vehicle is stable before proceeding.
Remove the Wheel: Remove the wheel on the side where the spring pocket is to be installed.
Keep the lug nuts in a safe place.
Locate the Spring Pocket: Identify the existing spring pocket. It is usually located near the suspension coil spring.
Remove the Old Spring Pocket: Use appropriate tools to remove the bolts or clips securing the old spring pocket. Carefully take out the old spring pocket.
Install the New Spring Pocket: Position the new spring pocket in place.
Secure it with the bolts or clips that were removed earlier. Ensure it is properly aligned.
Reattach the Wheel: Put the wheel back on and hand-tighten the lug nuts. Lower the vehicle back to the ground using the hydraulic jack.
Tighten the Lug Nuts: Once the vehicle is on the ground, use a torque wrench to tighten the lug nuts to the manufacturer’s specified torque.
Reconnect the Battery: Reconnect the vehicle’s battery.
Test the Installation: Start the vehicle and test drive it to ensure everything is working correctly.
Listen for any unusual noises and check for proper suspension function.
Final Check: Inspect the installation area to ensure all components are secure and properly installed.
Inspect the BMW Part Spring Pocket 41147057297 regularly for signs of wear, rust, or damage. Check the center hole for any deformation or weakening, as this can cause the shock stem to come through and create excessive noise in the rear suspension.
Replace the spring pocket if you notice any of these issues, or if it has been more than 100,000 miles since the last replacement. Always use genuine BMW parts to ensure proper fitment and performance.
The BMW Part Spring Pocket 41147057297 is a crucial component in BMW vehicles, designed to ensure smooth suspension operation. It’s essential for maintaining stability and ride comfort.
This part is compatible with various BMW models and should be replaced every 100,000 miles or if signs of wear are detected.
Regular inspection and replacement with genuine BMW parts are vital for optimal performance.
