The BMW Part Clip, Drip Moulding 51137258183 is a small but important piece in BMW cars. It keeps the rubber strip along the windshield edge in place. This strip helps keep water out by directing it away from the windshield and reduces wind noise too.
The BMW Part Clip, Drip Moulding 51137258183 is a genuine BMW accessory designed to secure the drip moulding, which is the rubber strip that runs along the edge of the windshield. This clip ensures that the moulding stays in place, preventing water from seeping into the vehicle.
Manufacturer: BMW
Part Number: 51137258183
Item Weight: 0.40 pounds
Fitment: Compatible with various BMW models from 2012 to 2024, including BMW 320i, 328i, 330i, X3, and X4.
Material: High-quality plastic designed for durability and longevity.
The drip moulding clip is essential for maintaining the integrity of the windshield seal. Over time, the clips can become worn or damaged, leading to water leaks and potential damage to the interior of the car.
Replacing these clips ensures that the moulding remains securely in place, preventing water ingress and maintaining the vehicle’s aesthetic appeal.
Preparation: Ensure the vehicle is parked on a flat surface and the engine is turned off. Gather the necessary tools, including a trim removal tool and a new set of drip moulding clips.
Remove Old Clips: Use the trim removal tool to carefully pry off the old drip moulding clips. Be gentle to avoid damaging the moulding or the windshield.
Install New Clips: Align the new drip moulding clips with the holes where the old clips were removed.
Press them firmly into place until they click securely.
Check Alignment: Ensure that the moulding is properly aligned and securely fastened. Test by gently tugging on the moulding to confirm it is securely in place.
Regular Inspection: Periodically check the drip moulding and clips for signs of wear or damage. Replace them as needed to prevent water leaks.
Use Correct Tools: Always use the appropriate trim removal tool to avoid damaging the moulding or clips.
Follow Manufacturer Guidelines: Refer to the BMW service manual for specific instructions and recommendations for your vehicle model.
By following these steps and tips, you can ensure that your BMW’s drip moulding remains in excellent condition, protecting your vehicle from water damage and maintaining its appearance.
The BMW Part Clip, Drip Moulding 51137258183 is a crucial component in maintaining the integrity of your BMW’s windshield seal.