The BMW Part shaft seal 24317519352 is an important part in BMW cars. It helps stop oil leaks and keeps the transmission system well-lubricated so it runs smoothly.
The BMW Part shaft seal 24317519352, also known as the Automatic Transmission Oil Pump Seal, is a crucial component in BMW vehicles. This seal is responsible for preventing transmission fluid leaks from the input or output shaft of the transmission or transfer case. It ensures that the transmission operates smoothly and efficiently by maintaining the proper fluid levels.
The 24317519352 shaft seal is compatible with a wide range of BMW models from 2002 to 2015.
Some of the specific models include:
2006-2013 BMW 128i (Convertible, Coupe, Sedan)
2008-2010 BMW 135i (Convertible, Coupe)
2006-2011 BMW 323i (Sedan)
2006-2013 BMW 328i (Convertible, Coupe, Sedan, Wagon)
2006-2011 BMW 325i (Sedan, Wagon)
2009-2011 BMW 335d (Sedan)
2004-2013 BMW X5 (Various models)
Preparation: Ensure the vehicle is parked on a level surface and the engine is turned off. Disconnect the battery to prevent any electrical issues.
Drain Transmission Fluid: Place a drain pan under the transmission and remove the drain plug to allow the transmission fluid to drain completely.
Remove Transmission Pan: Loosen and remove the bolts securing the transmission pan. Carefully remove the pan to avoid spilling any remaining fluid.
Locate the Shaft Seal: The shaft seal is located at the input or output shaft of the transmission or transfer case.
It may be necessary to remove additional components to access the seal.
Remove the Old Seal: Use a seal puller or a similar tool to carefully remove the old shaft seal without damaging the surrounding components.
Clean the Area: Thoroughly clean the area around the shaft to ensure there are no contaminants that could damage the new seal.
Install the New Seal: Apply a thin layer of transmission fluid to the new seal and the shaft. Carefully press the new seal into place using a seal driver or a similar tool.
Reassemble Components: Reinstall any components that were removed to access the shaft seal. Ensure all bolts are tightened to the manufacturer’s specifications.
Refill Transmission Fluid: Reinstall the transmission pan and fill the transmission with the appropriate amount of fresh transmission fluid.
Reconnect Battery: Reconnect the battery and start the engine.
Check for any leaks and ensure the transmission is operating smoothly.
To maintain the functionality and longevity of the shaft seal, it is important to:
Regularly Check for Leaks: Inspect the area around the transmission and transfer case for any signs of fluid leaks. Address any leaks promptly to prevent damage to the seal and other components.
Use High-Quality Fluids: Ensure that only high-quality transmission fluids are used to minimize wear and tear on the seal.
Follow Manufacturer’s Maintenance Schedule: Adhere to the recommended maintenance schedule provided by BMW to ensure all components, including the shaft seal, are inspected and replaced as needed.
Avoid Overheating: Prevent the transmission from overheating by ensuring proper cooling and avoiding excessive strain on the transmission.
By following these guidelines, you can ensure the shaft seal 24317519352 functions effectively and has a long service life in your BMW vehicle.
The BMW Part shaft seal 24317519352, also known as the Automatic Transmission Oil Pump Seal, is a crucial component in BMW vehicles.
